PC assembly

Assembly Tips
1. Avoid assemble in a state of sweaty 
2. Avoid holding or touching the feet straight pin processors available, including chipsets.
3. At each stage of assembly, power supply must be turned off.  
4. The equipment required is prepared before starting the assembly.
Step - step assemble a PC
1. Leaving the motherboard where the flat or over the casing in a safe place.  
2. Install the processor on the motherboard. (Type of processor and motherboard adjusted).  
3. Install internal memory on the motherboard. (Using the rule of thumb and technical rules).  
4. Preparing the chassis for mounting the motherboard. 
5. Install the bolts and screws are in place. 
6. Insert the motherboard on the casing slowly.  
7. Install the bolts provided on Motherboard  
8. Install and tighten all the bolts on the motherboard  
9. Replacing the Power Supply connector on the motherboard.  
10. Memasanglah VGA card in the appropriate expansion slot and the retaining bolts.  
11. Install Network card in the appropriate slot and tighten the bolt  
12. Replacing Hard Disk on the casing, and 4 bolts retaining  
13. Insert the CD drive in the casing and the retaining bolts on the side.  
14. Install the FDD in the framework of the casing and the retaining bolts on the side  
15. Setting jumpers on the HDD and CDD. If using a data cable, the HDD as Master, and CD drive as the Slave.  
16. Installing the data cable on the HDD and CDD. (Usually the foot 1 is located closest to the slot power) 17. Replacing the Hard Disk Power Cable  
18. Replacing Power Cord CD drive  
19. Installing the data cable Floppy Disk Drive  
20. Replacing the Floppy Disk Drive power cable  
21. Replacing all the data cables on the motherboard. Note the mounting pin 1 on the motherboard.     Replacing the cable switch, speaker, hdd LED and power LED on the motherboard. Follow the instructions in the manual of each motherboard.  
22. Replacing the Keyboard, Mouse, Data Monitor, Power Monitor and Power Cables at the back of the casing in keeping with their respective connectors.
23. Test performed by turning on your computer  
24. good luck ...........!!!!